RadioMaster RP3 V2 ExpressLRS 2.4GHz Nano Receiver

RadioMaster RP3 V2 Overview Introducing the RadioMaster RP3 V2 ExpressLRS 2.4GHz Nano Diversity Receiver, a cutting-edge ISM device engineered to elevate your telemetry and signal reception capabilities to unprecedented levels. With an optimized PCB design, this receiver ensures superior heat dissipation, guaranteeing sustained performance even under demanding conditions. Equipped with a Low Noise Amplifier (LNA), the RP3 extends the receiver range, capturing signals with enhanced sensitivity for seamless communication. Complementing this is a Power Amplifier (PA) that pushes telemetry range boundaries, empowering your system with extended reach and reliability. Unmatched signal stability and range are achieved through Antenna Diversity technology, enabling seamless switching between antennas for optimal reception in any scenario. The inclusion of a temperature-compensated crystal oscillator (TCXO) further refines performance, maintaining precise frequency synchronization for consistent, reliable operation across varying conditions. Operating within the 2.4GHz spectrum, the RP3 is compatible with all 2.4GHz ExpressLRS modules and transmitters, ensuring seamless integration with your existing setup. With telemetry RF power reaching a maximum of 100mW, you can harness the full potential of your telemetry system with confidence. Featuring dual 65mm 2.4GHz T Antennas, the RP3 delivers comprehensive coverage across the frequency range of 2.404 – 2.479 GHz. Whether you’re pushing the limits with high refresh rates of up to 500Hz or ensuring reliable performance at a minimum of 25Hz, the RP3 stands ready to meet your demands. Compact and lightweight at just 4.6g (including antennas), the RP3 is designed for efficiency without compromising on performance. Its compact dimensions of 22 x 13 x 4mm make it suitable for a wide range of applications, from FPV drones to remote-controlled vehicles. Pre-installed with ExpressLRS v3.0 firmware and tailored for compatibility with the RadioMaster RP3 Diversity 2400 RX, the RP3 simplifies setup while providing the flexibility to adapt to your specific requirements. With a convenient CRSF bus interface, integration into your existing system is seamless, allowing you to focus on pushing boundaries without constraints. Experience the future of telemetry and signal reception with the RP3 Diversity Receiver. For a comprehensive reading of related products, please visit the Motionew website. RadioMaster RP3 V2 ExpressLRS 2.4GHz Nano Receiver – FAQ What are the key technical specifications of the RP3 V2 receiver? The RP3 V2 operates in the 2.404–2.479 GHz range with telemetry RF power up to 100 mW. It supports a maximum receive refresh rate of 500 Hz (and F1000 Hz mode), weighs approximately 4.6 g including antennas, and measures 22 × 13 × 4 mm. Which features enhance reception and signal stability? The receiver includes antenna diversity with dual 65 mm T-antennas, a low-noise amplifier for improved sensitivity, and an optimized PCB design for efficient heat dissipation and stable long-range performance. What firmware and protocol support does the RP3 V2 offer? It comes pre-installed with ExpressLRS v3.0 firmware and communicates via the CRSF (Crossfire) protocol, ensuring compatibility with ExpressLRS 2.4 GHz transmitters and modules. Does MotioNew offer OEM or customization options for the RP3 V2? Yes, OEM customization is available for bulk and enterprise orders, including private labeling, firmware configuration, and packaging options. What payment methods can be used to purchase the RP3 V2 receiver? MotioNew accepts international payments through credit cards, PayPal, and bank transfers. Are user manuals and setup documents included? Yes, each RP3 V2 package includes a user manual, CRSF wiring cable, and dual antennas. Additional setup guides and firmware update instructions are available upon request.