Flight stack GEPRC F405 FC+ 50A ESC 4 in 1 2-6S

Description Flight stack GEPRC F405 FC+ 50A ESC 4 in 1 2-6S is equipped with 4 levels of battery indicator, barometer, and supports BLE Bluetooth for flight controller customization. With 8 outputs for m1-m8 motors, the controller becomes universal for most FPV copters. The manufacturer also paid attention to security, providing support for up to 4 GB of Blackbox data via the SD card slot. A 1500 µF capacitor performs the filtering function. The BOOT button has several options for use: If you press and hold BOOT while the FC is powered on, it is used to force the FC into DFU mode when you need to change the firmware on the FC. When the PC is turned on and in standby mode, the BOOT key can be used to control the LED strips connected to the LED1-LED4 connectors on the bottom side. A short press on BOOT will switch to the LED display mode. Press and hold the BOOT key to toggle between SpeedyBee-LED mode and BF-LED mode. When switching to BF-LED mode, all LED1-LED4 lines are controlled by the Betaflight firmware. Characteristics MCU: STM32F405 IMU Gyro: BMI270 Ports: Type-C Built-in barometer OSD chip: AT7456E BLE Bluetooth support for flight controller setup DJI Air Unit: via 6-pin connector or soldering connection Memory card: Blackbox MicroSD BetaFlight camera control panel Input power: 3S – 6S Lipo ESC outputs: M1 – M4 on the bottom side and M5 – M8 on the top side UART: 6 sets (UART1, UART2, UART3, UART4 (for ESC telemetry), UART6) ESC: Telemetry UART R5(UART5) I2C support Buzzer support BOOT button for setup RSSI input and SmartPort Firmware support: BetaFlight(Default), EMUFlight, INAV Firmware target: SPEEDYBEEF405V3 Mounting scheme: 30.5×30.5mm (4mm hole diameter) Dimensions: 41.6×39.4×7.8mm